Width: 7 1/8"
Height: Same as OEM
"An Element seat is an ultimate tool for any off-road enthusiast. Whether you're an aggressive rider looking to get more traction along with unmatched comfort or fighting off a waterlogged seat in the summer and an ice block in the winter. The Element seat comes with four traction ribs at the rear to keep you firmly planted in the cockpit comprised entirely of our gripper material. Secondly, each Element seat comes seam sealed from the inside to prevent water from penetrating into the foam. We don't stop there, before the cover is installed each foam is covered with a thin water barrier as added protection from the elements.
Rain...Snow...Mud or anywhere in between the Element seat is a must have for year-round use.
-Seat Concepts seats are constructed using a foam material that is a much higher quality than OEM seat foam. Our proprietary formula provides a more plush and active ride, while still offering the necessary amount of support. Our unique comfort shape maintains a similar contour to stock at the front of the seat so the rider’s legs are not spread farther apart, but tapers out towards the mid-point to distribute rider weight over a greater area.
These features combine to offer a custom seat feel, and provide greater enjoyment and increased range on a long commute, or Dual-Sport ride!"
Note:
Some 2016 models did not have an indentation in the underside of the seat pan called a pan pocket that provides additional clearance for an electrical module that will be present on TPI models. Our LOW foam and cover kit only works on models WITHOUT the pan pocket. Verify if your stock pan has a pocket if ordering a kit. Our Standard height and Tall models are available as a foam and cover kit, for models with or without a pan Pocket. All standard and tall Seat Concepts 2016-18 KTM Complete seats have pan pockets. Our low seat will NOT work on the TPI models.
Fits Years/Models:
2015 450SX Factory Edition
2016 SX 125
2016 SXF 250, SXF 350, SXF 450
2016 XCF 250, XCF 350, XCF 450
2017 SX 125, SX 150, SX 250
2017 SXF 250, SXF 350, SXF 450
2017 XC 300
2017 XC-W 150, XC-W 250, XC-W 300
2017 EXC-F 250, EXC-F 350, EXC-F 500
2017 XC-F 250 XC-F 350, XC-F 450
2018 SX 125, SX 250
2018 SXF 250, SXF 350
2018 XC 300
2018 XC-W 150, XC-W 250, XC-W 300
2018 EXC-F 250, EXC-F 350, EXC-F 500
2018 XC-W TPI 250
2019 EXC-F 350, EXC-F 450, EXC-F 500
2019 XC-W TPI 250, XC-W TPI 300
2019 XC-W 150
WILL NOT FIT:
2018 450SX-F Factory Edition
Important Information:
Per OEM specifications, the seat bolts should be tightened NO MORE than 7 ft/lbs to prevent tightening or stripping. Over tightening can cause a failure. Cross threading can also be an issue and should be avoided. DO NOT use air tools to tighten seat bolts as it can cause them to be stripped.
